Rivera-primo Brute IV Uživatelský manuál

2108-0005INSTALLATION INSTRUCTIONS FORIt’s common knowledge that a belt drive primary can provide advantages and service that a chaincannot, especiall

123STEP 1:Begin by disconnecting battery cables. Removing all the OEMprimary-drive components including the inner primary cover,AND THE FACTORY INNER-

6543A3BSTEP 4:Install the Motor Plate (front section PP-303, PP-403, PP-503,or PP-603), start the four front section bolts, but only hand tight-en at

891011STEP 8:If you’re installing the Brute IV on a Dyna Glide, check forclearance between the rear of the starter ring gear and theswing arm pivot nu

12131415STEPS 12 & 13:With both pulleys and the belt installed theclutch plates can now be installed. Install theclutch plates in exactly the same

161718DO NOT OPERATEthis or any other Rivera Primo Inc. open-primary belt-drive without the proper safety guard or belt cover in place. A well designe

REPLACEMENT PARTS LISTOFFSET FRONT PULLEY INSERTS /(PULLEY/HARDWARE NOT INCLUDED)PP-IS-1A . . . . STANDARD INSERT (NO OFFSET)PP-IS-8A . . . . 1/4” (.2

CLUTCH ASSEMBLY - BRUTE IV TM / 3” WIDE / 8 mm BELTRIVERA PRIMO Inc. 12450 Whittier Blvd, WHITTIER, CA 90602(562) 907-2600 FAX (562) 907-2606 E-mail: